Jump to content

Recommended Posts

Posted

Good morning

 

I cannot get the Burn Mode to default to eject tray after the verification process, although, I have enabled this default through the settings::

 

Tools > Settings > Device > Eject Tray After... Verify [Enabled]

 

I am utilising a Project File to run a weekly job so I thought the setting would also be located in this file. However, the file contains a setting for Verify [Verify = 1] but not a setting for Eject Tray after verify.

 

post-46458-0-35540400-1340597422_thumb.jpg

ImgBurn.log

 

Any assistance would be appreciated

Posted

It's the 'Eject Tray After...' -> 'Write' that you need to enable.

 

The Verify one is for when you're in standalone Verify mode and makes no difference to a Verify that happens after/as part of a Write operation.

 

These are program settings though and nothing to do with a Build project - hence they aren't stored in a project file.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.