nickba Posted June 25, 2013 Share Posted June 25, 2013 Hi, I bought some DVD+R DL last week and I am receiving this error: "power calibration area is full." This error appears after about 3 minutes after I insert the disc. But the most interesting thing is that if I choose to continue after the error, imgburn burns and verifies the disc OK!!!! And the disc works fine. So is there a way to skip or disable the calibration area test? This way I will not have to wait 3 minutes with the drive trying to calibrate and give me the error. Link to comment Share on other sites More sharing options...
RhoTrux64 Posted June 25, 2013 Share Posted June 25, 2013 Untick "Perform OPC before burning", if enabled. Link to comment Share on other sites More sharing options...
nickba Posted June 25, 2013 Author Share Posted June 25, 2013 Thanks for replying, but the OPC is already disabled!! Any other tips? Link to comment Share on other sites More sharing options...
RhoTrux64 Posted June 25, 2013 Share Posted June 25, 2013 Related to this subject in similar threads, it is suggested that the media could be the issue, burner firmware may need updating or the burner may be on it's last leg. Try burning at a different supported speed, clean the laser, try a better quality brand of disc. Link to comment Share on other sites More sharing options...
spinningwheel Posted June 25, 2013 Share Posted June 25, 2013 Related to this subject in similar threads, it is suggested that the media could be the issue, burner firmware may need updating or the burner may be on it's last leg. Try burning at a different supported speed, clean the laser, try a better quality brand of disc. Link to comment Share on other sites More sharing options...
nickba Posted June 29, 2013 Author Share Posted June 29, 2013 Hi, The problem was the DVD media. Bought another brand, problem solved!! Thanks Link to comment Share on other sites More sharing options...
Recommended Posts