nickba Posted June 25, 2013 Posted June 25, 2013 Hi, I bought some DVD+R DL last week and I am receiving this error: "power calibration area is full." This error appears after about 3 minutes after I insert the disc. But the most interesting thing is that if I choose to continue after the error, imgburn burns and verifies the disc OK!!!! And the disc works fine. So is there a way to skip or disable the calibration area test? This way I will not have to wait 3 minutes with the drive trying to calibrate and give me the error.
nickba Posted June 25, 2013 Author Posted June 25, 2013 Thanks for replying, but the OPC is already disabled!! Any other tips?
RhoTrux64 Posted June 25, 2013 Posted June 25, 2013 Related to this subject in similar threads, it is suggested that the media could be the issue, burner firmware may need updating or the burner may be on it's last leg. Try burning at a different supported speed, clean the laser, try a better quality brand of disc.
spinningwheel Posted June 25, 2013 Posted June 25, 2013 Related to this subject in similar threads, it is suggested that the media could be the issue, burner firmware may need updating or the burner may be on it's last leg. Try burning at a different supported speed, clean the laser, try a better quality brand of disc.
nickba Posted June 29, 2013 Author Posted June 29, 2013 Hi, The problem was the DVD media. Bought another brand, problem solved!! Thanks
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now