Build Destination cleared on ImgBurn exit instead of retained

[dbminter]

I installed ImgBurn on my new PC and imported a old .REG file to restore my settings.  I had to re-enter my Destination in Build mode for the target image file location when I built an image.  When I exit ImgBurn on my new system, this Destination is not retained like it was on my old PC.  It gets reset to a blank field.  Each time, I have to bring down the last image location and file name from the drop down list, which I use the same destination all the time in Build mode.

 

 

Any suggestions?

[LIGHTNING UK!]

You probably had a project file in the ImgBurn folder to configure that stuff each time you loaded the program.

[dbminter]

Oh, that's right!  I did have a Project file in the ImgBurn directory to load each time that I hadn't restored into the directory!