davexnet Posted September 5, 2016 Posted September 5, 2016 Hi I'd like to burn 3GB of data to a regular dvd-r, but I'd like the the burn to start offset from the normal inner groove so that the data more closely goes towards the outer edge. Is this possible? Is there anything in the interface to allow this, or perhaps a cue sheet? Any advice appreciated
LIGHTNING UK! Posted September 6, 2016 Posted September 6, 2016 There's something you can adjust on the Build tab in the settings that'll have the desired effect. Just make sure you change it back again.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now