larrybud Posted January 29, 2007 Posted January 29, 2007 ok, I went through the 4 hour process of creating the iso but unable to burn the disk. I had to do a reboot so I saved the project(at least I thought i did). I cannot locate the project. Is there anyway to reload the iso or do I need to delete it and start over?
LIGHTNING UK! Posted January 29, 2007 Posted January 29, 2007 4 hours to build an ISO?! It should take a couple of minutes! Anyway... yes you can of course burn the ISO, that's actually all ImgBurn used to be able to do - before 'Build' mode was added. Just switch to 'Write' mode, load the ISO file, insert a blank disc and then hit the 'Write' button. There's a guide for this in the 'Guides' forum.
dontasciime Posted January 29, 2007 Posted January 29, 2007 Big ISO. Not even BD-R iso would take that long.
polopony Posted January 29, 2007 Posted January 29, 2007 ok, I went through the 4 hour process of creating the iso but unable to burn the disk. I had to do a reboot so I saved the project(at least I thought i did). I cannot locate the project. Is there anyway to reload the iso or do I need to delete it and start over? I think you need to go back to the GUIDES forum and while you're at it check the DMA for your drives. I'm using an 800meg AMD cpu and from reading the video to the hard drive , building an ISO and then burning the ISO takes about 1 1/2 hours and my comp is really slow by todays standards so 4 hours in build mode then something is seriously wrong read and practice
larrybud Posted January 30, 2007 Author Posted January 30, 2007 ok, I went through the 4 hour process of creating the iso but unable to burn the disk. I had to do a reboot so I saved the project(at least I thought i did). I cannot locate the project. Is there anyway to reload the iso or do I need to delete it and start over? I think you need to go back to the GUIDES forum and while you're at it check the DMA for your drives. I'm using an 800meg AMD cpu and from reading the video to the hard drive , building an ISO and then burning the ISO takes about 1 1/2 hours and my comp is really slow by todays standards so 4 hours in build mode then something is seriously wrong read and practice
larrybud Posted January 30, 2007 Author Posted January 30, 2007 ok, I went through the 4 hour process of creating the iso but unable to burn the disk. I had to do a reboot so I saved the project(at least I thought i did). I cannot locate the project. Is there anyway to reload the iso or do I need to delete it and start over? I think you need to go back to the GUIDES forum and while you're at it check the DMA for your drives. I'm using an 800meg AMD cpu and from reading the video to the hard drive , building an ISO and then burning the ISO takes about 1 1/2 hours and my comp is really slow by todays standards so 4 hours in build mode then something is seriously wrong read and practice
larrybud Posted January 30, 2007 Author Posted January 30, 2007 In all fairness, I was creating the iso over a wireless G.
Recommended Posts