Stuck in the starting blocks

[c0llins05]

Hello there,

 

I've just downloaded the newest version of IMGburn with the intension of burning dual layer data DVD however when i come to burn my 1st disc it hit my first hurdle. IMGburn finds my device just fine as the log shows

 

I 08:38:30 ImgBurn Version 2.2.0.0 started!

I 08:38:30 Microsoft Windows XP Home Edition (5.1, Build 2600 : Service Pack 2)

I 08:38:30 Found 1 DVD?RW/RAM!

 

But when i insert a DVD-R DL i get this message at the main window

 

Device not ready (Trackin Servo Failure)

 

Now i used nero yesterday to burn a dvd movie so i am pretty sure the drive is ok, but then again thats not entirely true as it has troubles with standard c.d's

 

Any help would be greatly appreciated.

 

c0llins05

[lfcrule1972]

Is that the full error message ? Also can you confirm the make and model of your drive and firmware as well if possible. ImgBurn reports this for you....... look in the GUI window to the right

[LIGHTNING UK!]

Your drive probably doesn't support those discs.

 

Eject + reinsert it. The drive may recognise it properly after a second try.

 

This is nothing to do with the program, so to speak.

[c0llins05]

I'm using the mat"SHIT"a DVD-RAM UJ-820S 1.70 (ATA)

 

I didn't think it was anything do with the software but i figured you guys have heard a lot of problems so probably the best to help me out.

 

That is all the message says it's not an error message as such just appears in the bar along the bottom of the window

 

I'm on my way out the door now to go and buy a lite-on anywho

 

c0llins05

 

Works like a charm now!!

Edited March 15, 2007 by c0llins05