problem with burning a doublelayer

liasen · August 25, 2007

hi,

i cant burn any doublelayer disks. i tried it with different disk. this is the log.

I 19:49:06 ImgBurn Version 2.3.2.0 started!

I 19:49:06 Microsoft Windows XP Professional (5.1, Build 2600 : Service Pack 2)

I 19:49:06 Total Physical Memory: 523.808 KB - Available: 213.016 KB

W 19:49:06 Drive L:\ (FAT32) does not support single files > 4 GB in size.

I 19:49:06 Initialising SPTI...

I 19:49:06 Searching for SCSI / ATAPI devices...

I 19:49:06 Found 2 DVD-ROMs and 1 DVD±RW/RAM!

I 19:49:53 Operation Started!

I 19:49:53 Source File: P:\faa-cncs.iso

I 19:49:53 Source File Sectors: 4.024.730 (MODE1/2048)

I 19:49:53 Source File Size: 8.242.647.040 bytes

I 19:49:53 Source File Volume Identifier: CDROM

I 19:49:53 Source File File System(s): ISO9660; Joliet

I 19:49:53 Destination Device: [1:1:0] HL-DT-ST DVDRAM GSA-4120B A115 (R:) (ATA)

I 19:49:53 Destination Media Type: DVD+R DL (Disc ID: RICOHJPN-D01-67) (Speeds: 4x)

I 19:49:53 Destination Media Sectors: 4.173.824

I 19:49:53 Write Mode: DVD

I 19:49:53 Write Type: DAO

I 19:49:53 Write Speed: MAX

I 19:49:53 Link Size: Auto

I 19:49:53 Test Mode: No

I 19:49:53 BURN-Proof: Enabled

I 19:49:53 Optimal L0 Data Zone Capacity: 2.012.368

I 19:49:53 Optimal L0 Data Zone Method: ECC Block Boundary

hope someone can help. thanx!!

**LIGHTNING UK!** · August 25, 2007

The log isn't showing any error.

What do you think the problem is?

What's the message in the status bar?

Ditch the Ricoh discs and buy some decent Verbatim DVD+R DL ones instead. Burn at 2.4x

liasen · September 2, 2007

firmware update didn't worked. but i think it was an error/failure on the burning drive. now i have new drive and ImgBurn works fine.

thanks for your answer. sorry for my late response!

Recommended Posts