Devon Posted January 4, 2008 Posted January 4, 2008 I have to crank up the volume really high on the TV to hear any audio from the disc. Is it suppose to be like that or is this a problem the result of a mistake I made somewhere in the burning process?
blutach Posted January 4, 2008 Posted January 4, 2008 ImgBurn just feeds bits and bytes to your burner. It does nothing to them, including the audio packs in a DVD. Something else is wrong with your setup, I am afraid (check for loose wires from your standalone). Regards
LOCOENG Posted January 4, 2008 Posted January 4, 2008 Make sure you've selected the correct audio track as well, if you've selected the DTS track not all systems can handle it...but the AC3 track can be handled by most if not all equipment.
volvofl10 Posted January 4, 2008 Posted January 4, 2008 a few DVD authoring prog's cause this to happen as well try something else instead of the authoring prog you've been using, preferably one with an adjustable audio "Gain" setting
yetanother1 Posted February 27, 2008 Posted February 27, 2008 I've experienced the same problem with very low volume on the burned DVD. I burned the DVD from a .iso file. The reason I think that it is an ImgBurn problem is that I played the source .iso file on my PC (using VLC Media Player) and the volume was fine. The post about making sure that the correct audio track is confusing to me, as I can't find anyplace within ImgBurn where this is mentioned. Any thoughts? TIA
mmalves Posted February 27, 2008 Posted February 27, 2008 ImgBurn burns the ISO image as it is (i.e. it doesn't modify anything). Software player can increase the volume if it's too low (depends on the settings used) so usually it sounds better on a computer than on standalone DVD players.
Recommended Posts