Burneryo Posted June 7, 2008 Posted June 7, 2008 Hey.. I was hoping some1 could hlp me out When i try to write or erase something with imgburn it says "invalid operation command code" Any suggestions?
LIGHTNING UK! Posted June 7, 2008 Posted June 7, 2008 That means you have the drive connected to a controller with bad drivers that don't support optical drives. Try and find an update for them or more the drive to a different controller.
Burneryo Posted June 7, 2008 Author Posted June 7, 2008 I have alredy downloaded the newest drivers but i dont know ho to change what controller its connected to can you tell me how to change it plz
LIGHTNING UK! Posted June 7, 2008 Posted June 7, 2008 open the case and move the cable What drivers did you download / install? What motherboard do you have? (if you know)
Burneryo Posted June 7, 2008 Author Posted June 7, 2008 how would i check to see what motherboard i have?
Burneryo Posted June 7, 2008 Author Posted June 7, 2008 O ya and i cant open my case there some sort of clip thing holding it in and it wont budge
Cynthia Posted June 7, 2008 Posted June 7, 2008 how would i check to see what motherboard i have? This tool should give you the motherboard model in the tab 'Hardware'. http://www.nero.com/eng/downloads-infotools.html
Burneryo Posted June 7, 2008 Author Posted June 7, 2008 Thx Cynthia As for your earlier question Lightning.. its a Assutek computer INC. NODUSM3 1.05
Recommended Posts