jzs Posted October 26, 2008 Posted October 26, 2008 here is my no sound problem log.can anyone figure out why it plays for a minute with no sound and then goes blank?I 08:59:59 ImgBurn Version 2.4.2.0 started! I 08:59:59 Microsoft Windows XP Professional (5.1, Build 2600 : Service Pack 3) I 08:59:59 Total Physical Memory: 260,912 KB - Available: 89,608 KB I 08:59:59 Initialising SPTI... I 08:59:59 Searching for SCSI / ATAPI devices... I 09:00:00 Found 1 DVD-ROM and 1 DVD
Cynthia Posted October 26, 2008 Posted October 26, 2008 I 09:30:11 Average Write Rate: 768 KB/s (0.6x) - Maximum Write Rate: 819 KB/s (0.6x)I 09:59:40 Average Verify Rate: 772 KB/s (0.6x) - Maximum Verify Rate: 819 KB/s (0.6x) With those "speeds" it looks as you connected the USB connection to a non USB 2.0 connection. What program do you use to play the burned disc?
volvofl10 Posted October 26, 2008 Posted October 26, 2008 with video and sound, what goes in is what comes out ImgBurn does nothing to either of these, so you need to check your source file for the same faults
jzs Posted October 26, 2008 Author Posted October 26, 2008 I 09:30:11 Average Write Rate: 768 KB/s (0.6x) - Maximum Write Rate: 819 KB/s (0.6x)I 09:59:40 Average Verify Rate: 772 KB/s (0.6x) - Maximum Verify Rate: 819 KB/s (0.6x) With those "speeds" it looks as you connected the USB connection to a non USB 2.0 connection. What program do you use to play the burned disc? windows media player
Cynthia Posted October 26, 2008 Posted October 26, 2008 If you play the source video file from you hard disk, does it then turn up with picture and sound?
jzs Posted October 26, 2008 Author Posted October 26, 2008 If you play the source video file from you hard disk, does it then turn up with picture and sound? yes it plays wonderful on windows media player.when i look at properties for the video ts files it says"open with... and it is set to open with image burn,should it be set to something else?
Cynthia Posted October 26, 2008 Posted October 26, 2008 Might be that the transfer speed from your USB writer/reader is to low to be able to play the disc without those problems that you are facing. The speeds indicates that you have it connected to a USB 1.0/1.1 connection.
mmalves Posted October 26, 2008 Posted October 26, 2008 I 09:00:47 Destination Device: [0:0:0] LITE-ON DVDRW SHW-160P6S PS08 (E:) (USB) There's newer firmware PS0C available for your burner (remove any disc and close the tray before applying the firmware).
Recommended Posts