I/O Error with 2 burners

[Big Brother]

I have burned many many dvd's at 12x without a problem using imgburn until today when I recieved a I/O Error on my primary DVD burner on ATAPI. It does this after about 1.5 minutes after writing lead-in. Here is what I have done so far. Tried burning at 4x 6x and was successful. However can't burn anything above 6x. Tried Uninstalling IDE channel, tried updating firmware, tried 2nd burner on SATA. Both drives give me the same error. Here is the log.

 

I 20:27:30 ImgBurn Version 2.4.2.0 started!

I 20:27:30 Microsoft Windows XP Media Center Edition (5.1, Build 2600 : Service Pack 3)

I 20:27:30 Total Physical Memory: 2,095,580 KB - Available: 1,612,060 KB

I 20:27:30 Initialising SPTI...

I 20:27:30 Searching for SCSI / ATAPI devices...

I 20:27:30 Found 4 DVD-ROMs and 2 DVD

[Cynthia]

Hi and welcome to the forum, Big Brother!

 

Is that real or fake Taiyo Yuden media?

 

Used the same spindle of discs or opened up a new one?

[Big Brother]

Hi and welcome to the forum, Big Brother!

 

Is that real or fake Taiyo Yuden media?

 

Used the same spindle of discs or opened up a new one?

 

Yup this is real TY as this is the only media I use, have sampled from multiple spindles and same results. Have tried some other cheaper media with same results.

[Cynthia]

I 20:27:51 Advanced Settings - Force HT: Yes, Online HT: Yes, OverSpeed: Yes, SmartBurn: Yes

Tried to have all these settings disabled and only SmartBurn enabled? Sometimes with my own Lite-On's - those settings gave joke results.

 

I don't have your model, but my models usually gives the best result at 8x.