Using SPTI gives different errors

[imgk2000]

Good evening,

 

after producing a coaster this evening, the first for a very long time, I recognised that imgburn shows me some infomation I've never seen before.

I'm using a nf680i Mainboard two writers (sata PX-716, ide GSA-H20L) with up to date drivers for the board and firmware for the drives - non patched.

Normaly ImgBurn (2.4.2.0) shows in the status field "Device not ready (Medium not present)" when a drive is empty and the tray is closed. So it does

for the IDE drive. But not on the SATA PX-716! ImgBurn shows some of the following informations in the status field changing about ervery 2 seconds:

- Drive not ready (No additional sense Information)

- Drive not ready (Unknown, (0xnn, 0xnn) just two random hex bytes

- Drive not ready (Unknown, Vendor Unique (0xnn, 0xnn) just two random hex bytes

- Drive not ready (Diagnostic failed on component 0x7e)

... and some more

 

When switching the I/O setting to ASPI or ASAPI or ElbyCDIO (vso isn't installed so I can't use it) the drive shows up normal, also burning works,

just wrote four DL+R no problem.

 

System: XP SP3 up tp date patches, Nero7, AnyDVD (yes I bought it) - deactivated during the test.

 

What the heck is going on here? Any suggestions?

[LIGHTNING UK!]

It's the nforce drivers.

[imgk2000]

Thank you for your reply.

I see that this isn't a imgburn problem.

 

But what causes such a change in the behaviour of the system?

There was no driver or software update the last few days.

Any ideas?

 

Thank you.