Failed to set L0 data zone Error

[eagle777]

Hi

 

I had the same issue and read most of the posts and there are alot with the same issue, with all the same issue alot are having maybe it could be Imgburns problem may be a bug

because i went to burn a dual layer and i got the failed error few seconds after i pressed the burn button so i tried another of the same blanks and it worked, then the next project i went to burn was around the same size (both over 7GB) as the first so i tried the blank that was spat out first time and it didnt work so i tried a smaller DL (Under 7GB) image and tried the same blank and it worked all the DL burns i did verified and are working perfectly at 4x, and mine is a new burner with the latest firmware its a pioneer and the disc's are not verbatim. Maybe its a size issue with Imgburn dont take me the wrong way i am not pointing fingers (i think this is the best burning software bare none) i just thought this could help in trying to figure out the failed to set L0 data zone Error.

 

Thank u for ur time hope this helps.

[cornholio7]

and the disc's are not verbatim.

http://forum.imgburn.com/index.php?showtopic=8000

 

as much as you would like to think its not the discs that are the issue, it is

 

heres a disc greater than 7gb , one of many i have burned , notice the dye.

 

 

 

all burnt successfully om verbatim media

[eagle777]

Ok Thx for that i will try and get my hands on Verbatim DVD+R DL discs