I/O Error

[Superkaka1983]

Hi everyone, I done my best to try read through similar posts, but still cant get my ImgBurn to work.

It was all fine at the beginning, I had a few discs lying around the house (from Lidl) that worked perfectly, but couldnt get the same ones again. Got some verbatims as recommended, but still no joy. Any ideas would be greatly appreciated.

 

 

I 19:00:45 ImgBurn Version 2.4.2.0 started!

I 19:00:45 Microsoft Windows XP Home Edition (5.1, Build 2600 : Service Pack 2)

I 19:00:45 Total Physical Memory: 982,384 KB - Available: 616,200 KB

I 19:00:46 Initialising SPTI...

I 19:00:46 Searching for SCSI / ATAPI devices...

I 19:00:46 Found 1 DVD

[Cynthia]

Hi and welcome to the forum, Superkaka1983!

 

I 19:58:00 Average Write Rate: 618 KB/s (0.4x) - Maximum Write Rate: 1,134 KB/s (0.8x)

Try to enable DMA again.

 

http://forum.imgburn.com/index.php?s=&...dpost&p=967

[mmalves]

I 19:08:25 Destination Device: [4:0:0] HL-DT-ST DVDRRW GWA-4164B 1.01 (D:) (ATA)

I 19:08:25 Destination Media Type: DVD+R (Disc ID: MCC-004-00) (Speeds: 4x, 8x, 12x, 16x)

I 19:08:25 Write Speed: MAX

Try burning at 8x or 12x for a possibly better burn. You might also want to try firmware 1.05 for your burner (remove any disc and close the tray before flashing and reboot after it has finished).

[Superkaka1983]

Thanks very much, both of you, i'll try them out and let you know how I got on. Fingers crossed!!

[Superkaka1983]

Thanks guys, the burn went fine, just errored on the verify. Ive put two films on the one disc, the second seems to be jumping quite a lot, but the first seems perfect. Again thanks for helping out, i'll try some more and let you know how it goes.

 

Cheers!!!!

[Cynthia]

Can you post a log file from that latest burn. That it fails on the verify is not a good sign.