Jump to content

Keep getting "Layouts do not match error"


carstorm

Recommended Posts

I googled the drive string of the burner you're using.  It's a slim drive.  Slim drives are generally junk.  That's probably the problem.

 

 

You're using Verbatim MCC media, which is the best stuff out there, so it's not that.  Could be that drive doesn't like MCC media.  A firmware update might fix compatibility with that drive and media.  In Write mode, right click on the target drive and choose Check for firmware update.

 

 

Are these your first 6 attempts to burn with this drive and media?  Or have you been able to use it for some time and this issue just started up?  If that's the case, the drive might have probably reached the end of its life.

Link to comment
Share on other sites

I have burned 100s of ISOs (mostly movies and operating systems) in the last 5ish years using this setup with the most recent successful one being a Linux Distro about a month ago. This is the first time I have ever used Verbatim branded DVD-Rs though but based on the reviews, as you said, its a good brand. I have had most of them fail on burning (my last burn took 4 attempts before succeeding on the 5th. I will try your suggestion of updating the firmware. At this point I'm thinking I may have just gotten a bad batch of Blank DVDs?

Link to comment
Share on other sites

Well, it's always possible you got a bad batch of blanks, but highly unlikely.  If you've used this drive for 5 years, it's probably just died on you.  The best I've ever had a drive last is 2 years.

 

 

Since you've never used these Verbatims before, it's probably just a case of the drive not liking that media, which only a firmware update would fix. 

 

 

I say the problem is down to the drive, somehow.  Either it's died after 5 years of faithful service or its firmware doesn't like Verbatim MCC media.

Link to comment
Share on other sites

  • 2 weeks later...
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.