Jump to content
MarcusPatterson

Layer Break error when burning with ImgBurn

Recommended Posts

Hi

I'm trying to burn the following DVD folder to a DVD+R DL disc using ImgBurn.

rWz2q3d.png

ImgBurn refuses to burn the disc because it cannot set a layer break. This is the error message.

qGBxvcz.png

Can anyone help me on how to perform the operation requested by ImgBurn.

Thanks !

Share this post


Link to post
Share on other sites

There's really not much else you can do.  I don't know how to do it but there are supposedly ways you can manually set the layer break that may get around this.  Others may tell you how to do that. 

 

There is one thing you can do in the meantime.  You can use DVDShrink to shrink down your VIDEO_TS contents to a new VIDEO_TS.  Use a custom compression ratio and keep shrinking the VIDEO_TS down until you get a size ImgBurn is happy with.  However, this will reduce the video quality, and it will vary depending on how much you shrink it.  But, on an upscaling DVD, you won't notice it.  And if you only have to shrink it like 1% or 5%, again, you won't notice too much of a quality dip.

Share this post


Link to post
Share on other sites

I was thinking it should be in the Guides section.  I had forgotten it was already there under the title End Of The World problem.  :wink:

Share this post


Link to post
Share on other sites

×

Important Information

By using this site, you agree to our Terms of Use.