yellow calx

Well just ordered a Pioneer 112D since they are most compatible with 360 and burn well when using ImgBurn (or so a friend has said).

I forgot to upload the errors I got, it may explain what caused the failure?

I bought it off a friend so guess not. It's weird since it worked fine the other day when I burnt on a Verbatim. I've come across so similar posts on forums where people have had theirs start reading disks again, so I'll have to look into it more I guess. Thanks.

So I have a 360 image that I was going to burn on Verbatim Dual Layer disk (using a TS-H553A burner). I set everything up in settings (layerbreak, burn speed was at 2.4 etc.). Then I start the burning and have a bunch of errors pop up. After ignoring the first error, it kept retrying for ages and after around 20 goes I got a bunch more messages which I attached in the picture. I then ran the 360 image through Mulleter and it said it had no problems. So I took the disk out the drive, put it back in and it wasn't getting recognised. I just tried a whole bunch of DVDs/CDs and dual layers and none of them are being read now by any program. When I put a disk in it closes and there is no spinning sound. It's the first time I've used this drive to burn so at first I tried out new firmware. Deleted the old firmware, installed the new, restarted still have problems. I did some searching on the Microsoft help pages and used their registry tool to fix drive problems and after a restart it still doesn't work. The drive appears ok when viewed in the device manager, so I'm not sure what has caused this?