bidomo

Sorry, of course is a warning, I'll try burning some disk and see how it goes then, thanx Cynthia.

I Just bought a PIONEER BD-RW BDR-207D 1.21 (it states it's in RAID but it's connected to a JMicron SATA 3Gbps SATA port) and it always gives me this, I never tried burning a BR yet, as I don't know what it means... Any help will be highly appreciated Win 7 ultimate Motherboard Asus M5A99X EVO Phenom II x4 965e (o'ced to 4 Ghz) cooled by Noctua NH-D14 8 Gbs Corsair Vengance multiple hdds not in RAID. fully running as admin

Update ImgBurn. Also update your burner's firmware (remove any disc and close the tray before updating then reboot after it's finished). Try burning at 6x or 8x. You might want to try a lens cleaning disc on that drive. After doing all that, if it fails with Verbatim 2.4x blanks then you should start looking for a new burner Thanks for the reply! So, from what I understand, I can burn 2.4x verbatims at higher speeds? BTW, I've been burning games like nothing in the same drive and same firmware

Hi everyone! I'm new to the forums, but I've been using ImgBurn for quite a while. I've burned some DL's, some verbatim 2.4x DL's, and I've been reading about problems with DL's... Always use verbatims, so this is kind of strange (had a problem with some of them in the past but, the problem was the firmware on my burner). Tried burning in 4x, so I guess that was the problem, never had a single trouble reading or writing in this burner before, it's 1 year old This is the bad burn