First, as just seen I didn't used the actual version, I 'll correct but nevertheless
Pio 216D (L-patched), Win 7 x64 RC 7100
Normally my 216 should burn TDK RicohJPND01-67 media as my old optiarc did.
Yesterday I tried to burn a quite full DVD structure -> break at layer-break.
Today I tried a Blu Ray on another media, -> same procedure
I remember that I was always asked for setting the layerbreak position but not yet, the program ran without any commentary (ok, it's corrected the file system from UDF 1.5 to 2.5 )..against the wall
Failure in my version?
Disk too full?
; //****************************************\\
; ImgBurn Version 2.4.2.0 - Log
; Mittwoch, 07 Oktober 2009, 13:27:14
; \\****************************************//
;
;
I 13:09:12 ImgBurn Version 2.4.2.0 started!
I 13:09:12 Media Center Edition (6.1, Build 7100)
I 13:09:12 Total Physical Memory: 3.660.864 KB - Available: 2.090.880 KB
I 13:09:12 Initialising SPTI...
I 13:09:12 Searching for SCSI / ATAPI devices...
I 13:09:13 Found 1 DVD