I wrote a Win2K8 iso to a DVD+R a bit ago and it failed to boot (though ImgBurn says the burn was successful). I was also unable to open the DVD post-burn on a Win7 machine. The ISO is good, I mounted it with CloneDVD without issues. The PC (which I am running ImgBurn on) is a Win7 SP1, DELL Dimension 5150.
So, I tried a DVD-R (just in case - actually more than one, just to be sure). The drive would not initialize the disc. So I restarted and then decided to upgraded the firmware on my DVD/RW drive, after which I recieved the error below. So, I upgraded ImgBurn from 2.5.5.0 to 2.5.6.0. And I am still getting this same error.
The Log should be attached. As well as a screen shot of the GUI error which reads:
I/O Error!
Device: [0:0:0] HL-DT-ST DVD+-RW GSA-H21N B109 (D:) (ATA)
ScsiStatus: 0x02
Interpretation: Check Condition
CDB: 2A 00 00 00 00 00 00 00 20 00
Interpretation: Write (10) - Sectors: 0 - 31
Sense Area: 70 00 03 00 00 00 00 0E 00 00 00 00 0C 80 00 00 00 00
Interpretation: Unknown (Write Error) (ASC: 0x0C, ASCQ: 0x80)
2-22-2012 12-50-13 PM.bmp
ImgBurn.log
