Jump to content
Sign in to follow this  

Random Bug on build

Recommended Posts

Hi when I just started up ImgBurn and clickd to folder icon to choose a folder to build I go this error... Please be nice sorry if this is NOT a bug and tell me...




Ok like 2 seconds later i get the same problem problem...


I 00:59:01 ImgBurn Version started!

I 00:59:02 Microsoft Windows 7 Ultimate x64 Edition (6.1, Build 7601 : Service Pack 1)

I 00:59:02 Total Physical Memory: 8 379 444 KB - Available: 4 962 904 KB

W 00:59:02 DVDFab Passkey can interfere with ImgBurn's ability to verify accurately, please ensure it's disabled!

I 00:59:02 Initialising SPTI...

I 00:59:02 Searching for SCSI / ATAPI devices...

I 00:59:02 -> Drive 1 - Info: DTSOFT BDROM 1.05 (T:) (Virtual)

I 00:59:03 -> Drive 2 - Info: ATAPI iHAS524 B AL2A (S:) (ATA)

I 00:59:04 -> Drive 3 - Info: HL-DT-ST BD-RE BH10LS30 1.01-A0 (E:) (ATA)

I 00:59:04 Found 1 DVD±RW/RAM, 1 BD-ROM and 1 BD-RE!

I 01:00:43 Device: [2:0:0] HL-DT-ST BD-RE BH10LS30 1.01 (E:) (ATA)

I 01:00:43 Family Tree:

I 01:00:43 -> ACPI x64-based PC

I 01:00:43 -> Microsoft ACPI-Compliant System

I 01:00:43 -> PCI bus

I 01:00:43 -> Intel® 5 Series/3400 Series Chipset Family 2 port Serial ATA Storage Controller - 3B26 (VEN_8086&DEV_3B26 - Intel - pciide - v9.1.1.1013)

I 01:00:43 -> IDE Channel (ATA Channel 0)

I 01:00:43 -> CD-ROM Drive (HL-DT-ST BD-RE BH10LS30 ATA Device) (Channel 0, Target 0, Lun 0)

Edited by Adrianvdh

Share this post

Link to post
Share on other sites

That's just Windows messing around.


You must have used something on E: at some point and that drive is no longer valid/available but Windows is still trying to look at it and is throwing up that error.

Share this post

Link to post
Share on other sites

Well is it possible for ImgBurn to make that drive valid (like in a build in script in ImgBurn)?

Share this post

Link to post
Share on other sites
Sign in to follow this  


Important Information

By using this site, you agree to our Terms of Use.