Jump to content

Layer break setting not working on BD-RE DL


sylerner
 Share

Recommended Posts

I have an LG HL-DT-ST BD-RE  WH16NS40 blu-ray burner with version 1.03 firmware.  I am using imgburn on Linux using Crossover/Wine.

While burning a dual layer BD-RE disk, I noticed a lot of seeking near the end of layer 0.  I went into the settings and (since I needed very little of layer 1 to finish the disk) set the layer break to a value equal to 75% of a layer.

Despite this, when reburning the disk, it continued on layer 0 to the same point as before, again starting to seek excessively.

It seems that the layer break setting is being ignored.

Is this supposed to work on blu-ray disks?  If so, it would seem that we have a bug.  If not, to avoid confusion the setting should be labeled DVD layer break.

Any help will be greatly appreciated.

 

Link to comment
Share on other sites

 Share

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.