Finalise disc failed

[vladi]

Hi,

 

the session started as always, but when finalising a disc some strange noises occured from the burner, and after reaching 8%, the operation successfully completed message appeared.

 

This is the first time i got such message.

 

Btw., do i have to reburn it?- the menu appears successfully, tried to access some scene- also successfully.

 

Here's the log:

ImgBurn.log

[LIGHTNING UK!]

Your drive bombed out, not the program. (Moved to 'Support' forum)

 

2.4x might not be the optimal speed for your drive/firmware/media combo. Notice the supported speeds are 2.4x, 4x and 6x. MKM-003-00 is 8x media so faster might be better (I'd at least give 4x a go if it happens again).

 

You should verify your burns.

 

When you run into issues finalising, it's normally a case of certain players not recognising the disc. If it can see it at all, it should work fine.

[vladi]

Thanks for such a prompt answer

 

I tried 4X speed a couple of times, but such speed were not achieved (or achieved for the very short time) and it was burning at ~ 2,4- 3,2X (somewhere around that, can't remember exactly)

 

At 2,4X it burned fine until this session.

 

And i always thought, that the slower, the better