Red.Adair Posted June 25, 2012 Posted June 25, 2012 Good morning I cannot get the Burn Mode to default to eject tray after the verification process, although, I have enabled this default through the settings:: Tools > Settings > Device > Eject Tray After... Verify [Enabled] I am utilising a Project File to run a weekly job so I thought the setting would also be located in this file. However, the file contains a setting for Verify [Verify = 1] but not a setting for Eject Tray after verify. ImgBurn.log Any assistance would be appreciated
LIGHTNING UK! Posted June 25, 2012 Posted June 25, 2012 It's the 'Eject Tray After...' -> 'Write' that you need to enable. The Verify one is for when you're in standalone Verify mode and makes no difference to a Verify that happens after/as part of a Write operation. These are program settings though and nothing to do with a Build project - hence they aren't stored in a project file.
Recommended Posts