davexnet Posted September 5, 2016 Share Posted September 5, 2016 Hi I'd like to burn 3GB of data to a regular dvd-r, but I'd like the the burn to start offset from the normal inner groove so that the data more closely goes towards the outer edge. Is this possible? Is there anything in the interface to allow this, or perhaps a cue sheet? Any advice appreciated Link to comment Share on other sites More sharing options...
LIGHTNING UK! Posted September 6, 2016 Share Posted September 6, 2016 There's something you can adjust on the Build tab in the settings that'll have the desired effect. Just make sure you change it back again. Link to comment Share on other sites More sharing options...
Recommended Posts