Burneryo Posted June 7, 2008 Share Posted June 7, 2008 Hey.. I was hoping some1 could hlp me out When i try to write or erase something with imgburn it says "invalid operation command code" Any suggestions? Link to comment Share on other sites More sharing options...
LIGHTNING UK! Posted June 7, 2008 Share Posted June 7, 2008 That means you have the drive connected to a controller with bad drivers that don't support optical drives. Try and find an update for them or more the drive to a different controller. Link to comment Share on other sites More sharing options...
Burneryo Posted June 7, 2008 Author Share Posted June 7, 2008 I have alredy downloaded the newest drivers but i dont know ho to change what controller its connected to can you tell me how to change it plz Link to comment Share on other sites More sharing options...
LIGHTNING UK! Posted June 7, 2008 Share Posted June 7, 2008 open the case and move the cable What drivers did you download / install? What motherboard do you have? (if you know) Link to comment Share on other sites More sharing options...
Burneryo Posted June 7, 2008 Author Share Posted June 7, 2008 how would i check to see what motherboard i have? Link to comment Share on other sites More sharing options...
Burneryo Posted June 7, 2008 Author Share Posted June 7, 2008 O ya and i cant open my case there some sort of clip thing holding it in and it wont budge Link to comment Share on other sites More sharing options...
Cynthia Posted June 7, 2008 Share Posted June 7, 2008 how would i check to see what motherboard i have? This tool should give you the motherboard model in the tab 'Hardware'. http://www.nero.com/eng/downloads-infotools.html Link to comment Share on other sites More sharing options...
Burneryo Posted June 7, 2008 Author Share Posted June 7, 2008 Thx Cynthia As for your earlier question Lightning.. its a Assutek computer INC. NODUSM3 1.05 Link to comment Share on other sites More sharing options...
Recommended Posts