cbraxton Posted October 9, 2008 Share Posted October 9, 2008 I recently had to reload a Windows XP system due to hard drive failure. Prior to this, ImgBurn was working fine. After reloading, ImgBurn (version 2.4.2.0) now fails every time it tries to verify a DVD+R disc. On the same system using the same media, image, and burner, Nero version 6 works fine -- it burns and verifies the disc without incident. The computer is a few years old, a Dell Pentium-4 3.0GHz system with 2GB RAM and (now) a 500GB SATA hard drive. The DVD burner is an ATAPI Teac DVD+RW model DV-W58E. (Have already tried replacing the cable.) Discs are Philips DVD+R that ImgBurn IDs as CMC MAG-M01-00. What happens is that the disc appears to burn OK, and the verification pass runs until it gets to the 99% done mark, then starts issuing the diagnostic message "I/O Error, ScsiStatus: 0x02, Check Condition, Logical Block Address out of Range." The resulting disc plays without any obvious errors. The log file follows, any help in figuring out what's going on here, and why ImgBurn is bombing out under that same conditions in which Nero works, would be greatly appreciated! ============================================== ; //****************************************\\ ; ImgBurn Version 2.4.2.0 - Log ; Thursday, 09 October 2008, 07:41:24 ; \\****************************************// ; ; I 07:07:12 ImgBurn Version 2.4.2.0 started! I 07:07:12 Microsoft Windows XP Home Edition (5.1, Build 2600 : Service Pack 3) I 07:07:12 Total Physical Memory: 2,096,124 KB - Available: 1,720,200 KB I 07:07:12 Initialising SPTI... I 07:07:12 Searching for SCSI / ATAPI devices... I 07:07:12 Found 1 DVD-ROM and 1 DVD+RW! I 07:09:57 Operation Started! I 07:09:57 Source File: C:\tmp\dvdimage.iso I 07:09:57 Source File Sectors: 2,285,854 (MODE1/2048) I 07:09:57 Source File Size: 4,681,428,992 bytes I 07:09:57 Source File Volume Identifier: DVD001 I 07:09:57 Source File Volume Set Identifier: 007B147BDVDSHRINK I 07:09:57 Source File Implementation Identifier: DVD Shrink I 07:09:57 Source File File System(s): ISO9660, UDF (1.02) I 07:09:57 Destination Device: [2:1:0] TEAC DVD+RW DV-W58E D.0C (E:) (ATA) I 07:09:57 Destination Media Type: DVD+R (Disc ID: CMC MAG-M01-00) (Speeds: 2x, 4x) I 07:09:57 Destination Media Sectors: 2,295,104 I 07:09:57 Write Mode: DVD I 07:09:57 Write Type: DAO I 07:09:57 Write Speed: MAX I 07:09:57 DVD+R Reserve Track: Yes I 07:09:57 Link Size: Auto I 07:09:57 Test Mode: No I 07:09:57 OPC: No I 07:09:57 BURN-Proof: Enabled I 07:10:32 Filling Buffer... (40 MB) I 07:10:33 Writing LeadIn... I 07:10:35 Writing Session 1 of 1... (1 Track, LBA: 0 - 2285853) I 07:10:35 Writing Track 1 of 1... (MODE1/2048, LBA: 0 - 2285853) I 07:24:42 Synchronising Cache... I 07:24:43 Closing Track... I 07:24:44 Finalising Disc... I 07:25:00 Exporting Graph Data... I 07:25:00 Graph Data File: C:\Documents and Settings\Owner\Application Data\ImgBurn\Graph Data Files\TEAC_DVD+RW_DV-W58E_D.0C_THURSDAY-OCTOBER-09-2008_7-09_AM_CMC_MAG-M01-00_MAX.ibg I 07:25:00 Export Successfully Completed! I 07:25:00 Operation Successfully Completed! - Duration: 00:15:02 I 07:25:00 Average Write Rate: 5,397 KB/s (3.9x) - Maximum Write Rate: 5,566 KB/s (4.0x) I 07:25:00 Cycling Tray before Verify... I 07:25:19 Device Ready! I 07:25:21 Operation Started! I 07:25:21 Source Device: [2:1:0] TEAC DVD+RW DV-W58E D.0C (E:) (ATA) I 07:25:21 Source Media Type: DVD+R (Book Type: DVD-ROM) (Disc ID: CMC MAG-M01-00) (Speeds: 2x, 4x) I 07:25:21 Image File: C:\tmp\dvdimage.iso I 07:25:21 Image File Sectors: 2,285,854 (MODE1/2048) I 07:25:21 Image File Size: 4,681,428,992 bytes I 07:25:21 Image File Volume Identifier: DVD001 I 07:25:21 Image File Volume Set Identifier: 007B147BDVDSHRNK I 07:25:21 Image File Implementation Identifier: DVD Shrink I 07:25:21 Image File File System(s): ISO9660, UDF (1.02) I 07:25:21 Read Speed (Data/Audio): MAX / MAX I 07:25:21 Verifying Session 1 of 1... (1 Track, LBA: 0 - 2285853) I 07:25:21 Verifying Track 1 of 1... (MODE1/2048, LBA: 0 - 2285853) W 07:41:04 Failed to Read Sector 2285840 - Reason: Logical Block Address out of Range W 07:41:04 Sector 2285840 maps to File: \VIDEO_TS\VTS_02_1.VOB W 07:41:07 Failed to Read Sector 2285841 - Reason: Logical Block Address out of Range W 07:41:07 Sector 2285841 maps to File: \VIDEO_TS\VTS_02_1.VOB W 07:41:08 Failed to Read Sector 2285842 - Reason: Logical Block Address out of Range W 07:41:08 Sector 2285842 maps to File: \VIDEO_TS\VTS_02_1.VOB E 07:41:10 Failed to Read Sector 2285843 - Reason: Logical Block Address out of Range E 07:41:10 Sector 2285843 maps to File: \VIDEO_TS\VTS_02_1.VOB E 07:41:10 Failed to Verify Sectors! I 07:41:11 Exporting Graph Data... I 07:41:11 Graph Data File: C:\Documents and Settings\Owner\Application Data\ImgBurn\Graph Data Files\TEAC_DVD+RW_DV-W58E_D.0C_THURSDAY-OCTOBER-09-2008_7-09_AM_CMC_MAG-M01-00_MAX.ibg I 07:41:11 Export Successfully Completed! E 07:41:11 Operation Failed! - Duration: 00:15:49 I 07:41:11 Average Verify Rate: 4,817 KB/s (3.5x) - Maximum Verify Rate: 5,566 KB/s (4.0x) I 07:41:24 Close Request Acknowledged I 07:41:24 Closing Down... I 07:41:24 Shutting down SPTI... I 07:41:24 ImgBurn closed! Link to comment Share on other sites More sharing options...
LIGHTNING UK! Posted October 9, 2008 Share Posted October 9, 2008 Use ImgBurn to verify one of the Nero written discs and show me that log please. btw, if you've reloaded ImgBurn 2.4.2.0 from scratch, the 'DVD+R Reserve Track' option shouldn't be enabled by default and your log shows that it is. In any case, the program has written up to and including sector 2285853 and yet your drive is claiming anything after 2285839 is out of range... that can't possibly be true. Put the ImgBurn burnt disc back in the drive and copy + paste all the disc info text from the panel on the right. Link to comment Share on other sites More sharing options...
cbraxton Posted October 9, 2008 Author Share Posted October 9, 2008 Use ImgBurn to verify one of the Nero written discs and show me that log please. btw, if you've reloaded ImgBurn 2.4.2.0 from scratch, the 'DVD+R Reserve Track' option shouldn't be enabled by default and your log shows that it is. In any case, the program has written up to and including sector 2285853 and yet your drive is claiming anything after 2285839 is out of range... that can't possibly be true. Put the ImgBurn burnt disc back in the drive and copy + paste all the disc info text from the panel on the right. I don't think I changed any settings other than the log file location, to have that put in a more convenient place. (Should I uncheck the "Reserve Track" option and try again?) The Nero-burned disc was verified without errors, the log file and the disc info for the ImgBurn disc is below. (I'm pretty sure I have it right, I made two copies of the same disc, one with Nero and the other with ImgBurn and tried to keep straight which is which! Have to leave for work, but can do more tests later if needed...) ================================= ; //****************************************\\ ; ImgBurn Version 2.4.2.0 - Log ; Thursday, 09 October 2008, 08:46:46 ; \\****************************************// ; ; I 08:31:40 ImgBurn Version 2.4.2.0 started! I 08:31:40 Microsoft Windows XP Home Edition (5.1, Build 2600 : Service Pack 3) I 08:31:40 Total Physical Memory: 2,096,124 KB - Available: 1,728,316 KB I 08:31:40 Initialising SPTI... I 08:31:40 Searching for SCSI / ATAPI devices... I 08:31:40 Found 1 DVD-ROM and 1 DVD+RW! I 08:32:17 Operation Started! I 08:32:17 Source Device: [2:1:0] TEAC DVD+RW DV-W58E D.0C (E:) (ATA) I 08:32:17 Source Media Type: DVD+R (Book Type: DVD-ROM) (Disc ID: CMC MAG-M01-00) (Speeds: 2x, 4x) I 08:32:17 Image File: C:\tmp\dvdimage.iso I 08:32:17 Image File Sectors: 2,285,864 (MODE1/2048) I 08:32:17 Image File Size: 4,681,449,472 bytes I 08:32:17 Image File Volume Identifier: DVD001 I 08:32:17 Image File Volume Set Identifier: 00289D37DVDSHRNK I 08:32:17 Image File Implementation Identifier: DVD Shrink I 08:32:17 Image File File System(s): ISO9660, UDF (1.02) I 08:32:17 Read Speed (Data/Audio): MAX / MAX I 08:32:17 Verifying Session 1 of 1... (1 Track, LBA: 0 - 2285863) I 08:32:17 Verifying Track 1 of 1... (MODE1/2048, LBA: 0 - 2285863) I 08:46:41 Exporting Graph Data... I 08:46:41 Graph Data File: C:\Documents and Settings\Owner\Application Data\ImgBurn\Graph Data Files\TEAC_DVD+RW_DV-W58E_D.0C_THURSDAY-OCTOBER-09-2008_8-32_AM_CMC_MAG-M01-00.ibg I 08:46:41 Export Successfully Completed! I 08:46:41 Operation Successfully Completed! - Duration: 00:14:22 I 08:46:41 Average Verify Rate: 5,309 KB/s (3.8x) - Maximum Verify Rate: 5,566 KB/s (4.0x) I 08:46:46 Close Request Acknowledged I 08:46:46 Closing Down... I 08:46:46 Shutting down SPTI... I 08:46:46 ImgBurn closed! ================================= TEAC DVD+RW DV-W58E D.0C (ATA) Current Profile: DVD+R Disc Information: Status: Complete Erasable: No Sessions: 1 Sectors: 2,285,872 Size: 4,681,465,856 bytes Time: 508:00:22 (MM:SS:FF) Supported Write Speeds: 2x, 4x TOC Information: Session 1... (LBA: 0) -> Track 01 (Mode 1, LBA: 0 - 2285871) -> LeadOut (LBA: 2285872) Physical Format Information (Last Recorded): Disc ID: CMC MAG-M01-00 Book Type: DVD-ROM Part Version: 1 Disc Size: 120mm Maximum Read Rate: Not Specified Number of Layers: 1 Track Path: Parallel Track Path (PTP) Linear Density: 0.267 um/bit Track Density: 0.74 um/track First Physical Sector of Data Area: 196,608 Last Physical Sector of Data Area: 2,482,479 Last Physical Sector in Layer 0: 0 Link to comment Share on other sites More sharing options...
LIGHTNING UK! Posted October 9, 2008 Share Posted October 9, 2008 Going by that disc info, the last sector is 2285871 which is more than the last one ImgBurn wrote to (2285853 - and I'd expect that to be the case so don't worry!), so I really can't see what the problem is. If it knows the disc has 2285871 sectors available for reading, why is it saying 2285853 is out of range?! Try verifying the disc again now. Link to comment Share on other sites More sharing options...
Recommended Posts