Wheelie4 Posted August 5, 2006 Posted August 5, 2006 (edited) This is in no way a problem for me so I'm not complaining. Just posting an observation. I know that majority of the time I will build (on-the-fly) to device. So in Settings>Event tab>On Startup I set: Set Program Mode: Build Set Build Mode: Device and clicked OK But no matter what output mode I leave Imgburn in (image mode or device mode) when I exit. When I reopen Imgburn it's still in the last output mode it was in when exiting. If I exit with it in image mode, when I open Imgburn again it's still in image mode. BTW I did a clean install and rebooted after uninstalling v1.3 and rebooting. Wasn't sure it was a bug so I posted here. Aside from that, thank you so much lightningUK for this build mode. Edited August 5, 2006 by Wheelie4
LIGHTNING UK! Posted August 5, 2006 Posted August 5, 2006 Damn, good find! I must have forgotten to link that up properly when I added it! I've fixed it in an updated build on the ImgBurn download mirror.
Wheelie4 Posted August 5, 2006 Author Posted August 5, 2006 Dang! That was freaky fast. Much Appreciated.
LIGHTNING UK! Posted August 5, 2006 Posted August 5, 2006 Might aswell do it while I'm here and in the mood!
Wheelie4 Posted August 5, 2006 Author Posted August 5, 2006 (edited) Works now. Not that I doubted it would. It was as if you had Jeannie From "I Dream of Jeannie" just blink and it was linked. Thanks. Edited August 5, 2006 by Wheelie4
volvofl10 Posted August 5, 2006 Posted August 5, 2006 personally i wouldnt have bothered. i leave the lights on on my car when i go in the shop , i switch the car off and the lights go off, when i get back in and turn the engine on, the lights come back on what if the next time you want to start IB you want to use build mode again ? at least its in the mode i want and i dont have to change mode ! 6 of one half a dozen of the other really
Recommended Posts