dbminter Posted December 3, 2012 Share Posted December 3, 2012 What size are the screws that hold CD/DVD drives onto the side of the interior case of a PC? Are they the same size or smaller than so called PC Computer Case thumbscrews? Does anyone know? Link to comment Share on other sites More sharing options...
LIGHTNING UK! Posted December 3, 2012 Share Posted December 3, 2012 http://en.wikipedia.org/wiki/Computer_case_screws M3 screws for optical drives. Link to comment Share on other sites More sharing options...
dbminter Posted December 3, 2012 Author Share Posted December 3, 2012 That link does help a lot. So, 6-32 screws won't fit the hole for an M3 screw that holds an optical drive to the case? Basically, what I'd like to find are thumbscrews that are M3, it seems. I think this may be basically what I'm looking for? http://www.frozencpu.com/products/13513/scr-259/Dimastech_M3_Thread_Thumbscrew_-_10_Pack_BT016.html?tl=g4c157s1266&id=M5Saidgk Link to comment Share on other sites More sharing options...
LIGHTNING UK! Posted December 3, 2012 Share Posted December 3, 2012 Nope, the optical drive screws have a finer pitch thread. Yes, those M3 thumbscrews look like they should do the job Link to comment Share on other sites More sharing options...
dbminter Posted December 17, 2012 Author Share Posted December 17, 2012 They half did the job. They fit the holes fine, but, the side panel wouldn't fit back into place with some of the screws in place. There are 2 screw holes per side for the optical drives, and with screws in the rear hole, the side panel will slide back into place. With screws in the forward holes, though, the panel will not fit back because the side panel is not flat on the side. It's got ridges and grooves in it. So, I can only have screws in the rear holes. It seems to do the trick, though. The drives don't move too much when the eject buttons are pressed, so, it appears that just the one screw in the rear is enough. Link to comment Share on other sites More sharing options...
Recommended Posts