dbminter Posted September 12, 2014 Share Posted September 12, 2014 I installed ImgBurn on my new PC and imported a old .REG file to restore my settings. I had to re-enter my Destination in Build mode for the target image file location when I built an image. When I exit ImgBurn on my new system, this Destination is not retained like it was on my old PC. It gets reset to a blank field. Each time, I have to bring down the last image location and file name from the drop down list, which I use the same destination all the time in Build mode. Any suggestions? Link to comment Share on other sites More sharing options...
LIGHTNING UK! Posted September 12, 2014 Share Posted September 12, 2014 You probably had a project file in the ImgBurn folder to configure that stuff each time you loaded the program. Link to comment Share on other sites More sharing options...
dbminter Posted September 13, 2014 Author Share Posted September 13, 2014 Oh, that's right! I did have a Project file in the ImgBurn directory to load each time that I hadn't restored into the directory! Link to comment Share on other sites More sharing options...
Recommended Posts