Jump to content

Current Profile says DVD-R DL but, my disc is DVD+R DL


GuckTube

Recommended Posts

Hello, i just buy the DVD+R DL and burn xbox 360 games, when i try to put my disc into my drive, the current profile says DVD-R DL
and when i burn it, i try to check the current profile again, its says DVD-ROM

Logs before burn:

HL-DT-ST DVDRAM GH24NS96 CT01 (SATA)
Current Profile: DVD-R DL

Disc Information:
Status: Empty
State of Last Session: Empty
Erasable: No
Free Sectors: 4,171,712
Free Space: 8,543,666,176 bytes
Free Time: 927:04:62 (MM:SS:FF)
Next Writable Address: 0
MID: PRINCORDL32
Supported Write Speeds: 4x, 8x

DVD±R DL Boundary Information:
L0 Data Zone Capacity: 2,092,896
Changeable: No

DVD-R DL Shifted Middle Area:
Start Address: 2,092,896
Changeable: Yes

DVD-R DL Manual Layer Jump:
Address: Not Specified

Pre-recorded Information:
Manufacturer ID: PRINCORDL32

Physical Format Information (Last Recorded):
Disc ID: 0-00
Book Type: DVD-R
Part Version: 6
Disc Size: 120 mm
Maximum Read Rate: Not Specified
Number of Layers: 2
Track Path: Opposite Track Path (OTP)
Linear Density: 0.293 um/bit
Track Density: 0.74 um/track
First Physical Sector of Data Area: 196,608
Last Physical Sector of Data Area: 16,566,527
Last Physical Sector in Layer 0: 2,289,503

Performance (Write Speed):
Descriptor 1...
-> B0: 0x00, B1: 0x00, B2: 0x00, B3: 0x00
-> EL: 4171711 (0x003FA7BF)
-> RS: 16,620 KB/s (12x) - WS: 5,540 KB/s (4x)
Descriptor 2...
-> B0: 0x00, B1: 0x00, B2: 0x00, B3: 0x00
-> EL: 4171711 (0x003FA7BF)
-> RS: 16,620 KB/s (12x) - WS: 11,080 KB/s (8x)

Logs after burn:

HL-DT-ST DVDRAM GH24NS96 CT01 (SATA)
Current Profile: DVD-ROM

Disc Information:
Status: Complete
State of Last Session: Complete
Erasable: No
Sessions: 1
Sectors: 3,827,488
Size: 7,838,695,424 bytes
Time: 850:35:13 (MM:SS:FF)
MID: PRINCORDL32
Supported Write Speeds: 4x, 8x

TOC Information:
Session 1... (LBA: 0)
-> Track 01  (Mode 1, LBA: 0 - 3827487)
-> LeadOut  (LBA: 3827488)

Pre-recorded Information:
Manufacturer ID: PRINCORDL32

Physical Format Information (Last Recorded):
Disc ID: 0-00
Book Type: DVD-R
Part Version: 15
Disc Size: 120 mm
Maximum Read Rate: Not Specified
Number of Layers: 2
Track Path: Opposite Track Path (OTP)
Linear Density: 0.293 um/bit
Track Density: 0.74 um/track
First Physical Sector of Data Area: 196,608
Last Physical Sector of Data Area: 16,222,303
Last Physical Sector in Layer 0: 2,289,503

Performance (Write Speed):
Descriptor 1...
-> B0: 0x00, B1: 0x00, B2: 0x00, B3: 0x00
-> EL: 4171711 (0x003FA7BF)
-> RS: 8,310 KB/s (6x) - WS: 5,540 KB/s (4x)
Descriptor 2...
-> B0: 0x00, B1: 0x00, B2: 0x00, B3: 0x00
-> EL: 4171711 (0x003FA7BF)
-> RS: 8,310 KB/s (6x) - WS: 11,080 KB/s (8x)

And then i cannot set layer break position

Anyone can help me? Sorry if my grammar is bad

 

Edited by GuckTube
Link to comment
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.