choogiesaur Posted April 21, 2020 Posted April 21, 2020 hey y'all so I've been trying to burn some gamecube games in .iso format and getting mixed results: - one went through fine in imgburn, and didn't boot in the (modded) system. - one got a similar set of errors to below, and during the Verify phase it kept getting a popup error saying there was a mismatch. this however burned all the way and even appeared to load up fine on the gamecube - The one I'm trying now got the Potential Bogus Driver error, same as second one, except this one is now stuck at 65% and is not progressing. Below is the log and a screencap of where it's stuck at. I 17:22:26 ImgBurn Version 2.5.8.0 started! I 17:22:26 Microsoft Windows 8 Professional x64 Edition (6.2, Build 9200) I 17:22:26 Total Physical Memory: 12,574,188 KiB - Available: 7,877,588 KiB I 17:22:26 Initialising SPTI... I 17:22:26 Searching for SCSI / ATAPI devices... I 17:22:27 -> Drive 1 - Info: ATAPI iHAS424 Y ZL1W (E:) (SATA) I 17:22:27 Found 1 DVD±RW/RAM! I 17:22:36 Operation Started! I 17:22:36 Source File: C:\Users\Choogie\Downloads\Super Smash Bros. Melee (USA) (En,Ja) (Rev 2).iso I 17:22:36 Source File Sectors: 698,574 (MODE1/2048) I 17:22:36 Source File Size: 1,430,679,552 bytes I 17:22:36 Source File Volume Identifier: Super Smash Bros Melee I 17:22:36 Source File File System(s): Special I 17:22:36 Destination Device: [3:0:0] ATAPI iHAS424 Y ZL1W (E:) (SATA) I 17:22:36 Destination Media Type: DVD-R (Disc ID: RITEKG04 01) I 17:22:36 Destination Media Supported Write Speeds: 2x, 4x I 17:22:36 Destination Media Sectors: 713,936 I 17:22:36 Write Mode: DVD I 17:22:36 Write Type: DAO I 17:22:36 Write Speed: 2x I 17:22:36 Link Size: Auto I 17:22:36 Lock Volume: Yes I 17:22:36 Test Mode: No I 17:22:37 OPC: No I 17:22:37 BURN-Proof: Enabled I 17:22:37 Write Speed Successfully Set! - Effective: 2,770 KB/s (2x) I 17:22:37 Advanced Settings - Force HT: N/A, Online HT: N/A, OverSpeed: N/A, SmartBurn: Yes I 17:22:37 Filling Buffer... (80 MiB) I 17:22:38 Writing LeadIn... I 17:23:29 Writing Session 1 of 1... (1 Track, LBA: 0 - 698573) I 17:23:29 Writing Track 1 of 1... (MODE1/2048, LBA: 0 - 698573) W 17:24:43 Failed to Write Sectors 96704 - 96735 - Reason: Logical Unit Communication CRC Error (ULTRA-DMA/32) W 17:24:43 Retrying (1 of 20)... W 17:24:43 Retry Failed - Reason: Invalid Address For Write W 17:24:43 Potential Bogus Driver Error Detected! W 17:24:43 Retrying (2 of 20)... I 17:24:43 Writing Sectors... W 17:25:23 Failed to Write Sectors 149792 - 149823 - Reason: Logical Unit Communication CRC Error (ULTRA-DMA/32) W 17:25:23 Retrying (1 of 20)... W 17:25:23 Retry Failed - Reason: Invalid Address For Write W 17:25:23 Potential Bogus Driver Error Detected! W 17:25:23 Retrying (2 of 20)... I 17:25:23 Writing Sectors... W 17:29:03 Failed to Write Sectors 446656 - 446687 - Reason: Logical Unit Communication CRC Error (ULTRA-DMA/32) W 17:29:03 Retrying (1 of 20)... W 17:29:03 Retry Failed - Reason: Invalid Address For Write W 17:29:03 Potential Bogus Driver Error Detected! W 17:29:03 Retrying (2 of 20)... I 17:29:03 Writing Sectors...
dbminter Posted April 21, 2020 Posted April 21, 2020 Try using something other than cheaper DVD media. Try the DataLife Plus/AZO discs made by Verbatim. NOT the Life Series you find in stores. I 17:22:36 Destination Media Type: DVD-R (Disc ID: RITEKG04 01) The above generally indicates a lesser quality brand of recordable DVD. Some might work fine, some might not. That's the nature of cheaper quality media. It's the first thing I'd try. Try using Verbatim DataLife Plus/AZO discs you can only find online. Granted, I've never seen a Possible Bogus Driver error detected before, so it could be something else.
LIGHTNING UK! Posted April 22, 2020 Posted April 22, 2020 Check (and perhaps replace) the cable / port the drive is attached to. If you're getting CRC errors with the transfer of data to/from the drive, something isn't right somewhere.
choogiesaur Posted April 22, 2020 Author Posted April 22, 2020 @dbminter - forgot to mention I'm using mini dvd-r - they are branded Fujifilm and were quite expensive (though most mini dvd's are now) - and for gamecube I hear RITEK is the brand to go with, but I will try and get my hands on some different media @LIGHTNING UK! - that's a bit unsettling - I'll try jiggling/unplugging and replugging the wires thank you both!
dbminter Posted April 22, 2020 Posted April 22, 2020 I'm not familiar with mini DVD-R or burning GameCube games. The actual media you use for burning game discs doesn't matter, but the drive you use CAN. I'm not entirely sure if it applies to GameCube games, but I know you need special drives and loaders for XBox games. So you may need a particular type of burner like a LiteOn for GameCube games, though I believe it's XBox games that are so picky.
Recommended Posts